Load Equalizer

Load Equalizer


Applications: Used to correct fast flash and other problems associated with running LED motorcycle bulbs. For Intermittent use only, such as turn signals and bake lights.

Installation: Use one Load Equalizer for each LED bulb. No wire cutting required. Using pilers and supplied squeeze connectors, connect one wire to Turn Signal/Brake wire and the other to the ground wire in close proximity to bulb socket.

Caution: Load equalizer gets as hot as an incandescent bulb. Keep at least 1” away from anything susceptible to heat damage; use in open space.

Test: Verify that the problem is corrected. If not, check connections. If load equalizer is not warm, then the connections are bad, or wires are connected improperly.

For off-road use only; not a substitute for legal DOT lighting.

Add To Cart

WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov